[mnjettr]

for those that havn't read about intake plenum problems and cures pull your console off and check your intake. found a loose fitting on mine and a mis aligned clamp and a vent tube that had never been attached on my brothers both 08 models

[SandJunkie]

That was close...

[POWERTRIP]

Just checked mine and 2 of the different clamps for the intake Plenum were loose!!!!!!!!

That could have been costly.

Thanks for the heads up.

[mnjettr]

Originally Posted by POWERTRIP

Just checked mine and 2 of the different clamps for the intake Plenum were loose!!!!!!!!

That could have been costly.

Thanks for the heads up.

be sure to read up on the plenum fixes and issues,
(don't over tighten the clamps), zip tie or band clamp hold downs to name a few.

[fattnassty]

i took off the clamps and riveted the boots to the plastic bottle and then i put the clamps back on. the angles are off on all of the boots and collars.

[mnjettr]

Originally Posted by fattnassty

i took off the clamps and riveted the boots to the plastic bottle and then i put the clamps back on. the angles are off on all of the boots and collars.

was everything tight and in place when you checked it?

[scmo777]

Mine where all fine, but from past experiences with motorcycles and atv's, these are things that should be checked very regularly, should not rely on the dealer to have done it. Where did your vent line go? Maybe I am missing mine.

[mnjettr]

Originally Posted by scmo777

Mine where all fine, but from past experiences with motorcycles and atv's, these are things that should be checked very regularly, should not rely on the dealer to have done it. Where did your vent line go? Maybe I am missing mine.

top of the engine up to the plenum, you can see in the pic the nipple on the plenum where the vent tube attaches

[DASARACING]

We now have a sano fix for this plenum issue ...... This fix will offer a solid clamping surface for both of intake boots. It will not disrupt intake flow of the itnake and they are simple to install. You will not see them once they are installed and the intake plenum will not come off EVEN IF YOU TUG ON IT once these parts are installed. They will be $49.99 ...... all pre-orders will ship 4/24/2009

[DASARACING]

These parts are now instock and you can buy them right off our website.

CLICK HERE