Teryx HQ banner

Running probs after replacing CVT belt

1K views 0 replies 1 participant last post by  Astroarthur 
#1 ·
Hi everyone, new to the forum, thank you for admitting me.

We have a 2008 Teryx that died on a pig chase recently, the cvt belt snapped. Poor timing believe me. We managed to get a new one (original from kawasaki) and replaced it, wouldnt run found the bottom wire from the coil had fallen off, reconnected that started and run but now we are losing power that correlated to the speedo not registering. Have replaced the little sensor inside the oil reservoir, but still running like a dog, any other suggestions??? Than you in advance
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top