It wasn't hard Powertrip... Bought the flowmaster at Advance auto parts... think it was around 90$... two in. offset inlet two in. center outlet.. cut the end of my stock muffler off where it was welded to the canister and cut the inlet two in. end off the flowmaster flush with the canister (or main part of the muffler) took the inlet piece of the flowmaster and used it for a pattern so the stock inlet would be a good close fit to the smaller inlet of the flowmaster... welded it on with 7018 rods ( that was kind of hard ) Worst part was getting the inlet cut off the stock muffler. Thanks for the comments, Roger.
Last edited by wvhick; 06-11-2008 at 02:08 AM.