Teryx HQ banner

1 - 6 of 6 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter #1
I need a little help tuning my Teryx with muzzy exh. I am at the point where I need a air/fuel meter. I will probably get the NGK one for cost and simplicity.
1. Are the bungs that come already welded on the muzzy exh. in a ok location for tuning?

2. when tuning with the A/F Meter, I know the your to be aroung 13,

start at idle watch # on AFM and adjust air screw
next run at 1/4 -3/4 watch # on AFM and adjust needle
then run 3/4-WOT watch # on AFM and adjust main jet.

Is this correct? Please help.
 

·
Registered
Joined
·
144 Posts
I think he meant start at WOT.:laugh:
 

·
Registered
Joined
·
113 Posts
Discussion Starter #5
Thank You.....
The tech article really helped.
I started reading that in the past, but got lost in the 100 gallon water tank. My bad....
Turned out to be very helpful !

Todd, did Dalton kits and overdrives come in yet? ......
 
1 - 6 of 6 Posts
Top